A Beginners Guide To

How to Install Plumbing in a New House
Plumbing work in the water in and water out concept which is simple and has only three components, namely; supply system, drainage system and the fixture set, which require a licensed plumber for execution in many places or the person installing require to be guided by a licensed plumber, and the procedure is determined by the local plumbing codes and the layout of the house.
With the following paragraphs giving more information about each installation, the timetable is normally set that; the installation of the sewer accommodation stubs comes first before the concrete foundation has been laid, rough-in plumbing and duct installation comes in next when the wiring is being done after the wall framing has been set up but the dry wall has not been installed, and you should finally put the main drainage in the floor, install the water pipes, fit in the sinks, toilet flanges and tubing.
Plumbing fixtures need to be installed before you have set the walls, which is mainly caused by how big they are such as how shower units and bath tabs are and should be covered using soft or hard materials like rugs, cardboard or old blankets to avoid damage while finishing on the walls, after which you should connect commodes and sinks.
The water supply system consists of pressurized water that come in two lines, with one taking water to warm in the heater, and the other bringing in cold water to every appliance just like the one from the heater does, but other homes have water supply manifold system, which has blue and red valves that control cold or hot water entering the fixture and this is advantageous because it makes it easy to shut out the supply of water to only one appliance when there is need to without having to shut out the entire house from water supply.
For drainage purposes, the main vent runs vertically from the ground floor to the roof top towards which the waste is connected and is directed downwards to the main sewer drain and leaves the home below the frost line where it is connected to the municipal’s sewer system or is directed to a personal septic tank.
There should also be ventilation, which prevent water locks that cause clogs, and this is done by installing a vent behind sinks. A drain trap is also needed below sinks, tub drains, and showers and contains water that prevent sewer gases from getting back to the house.